Openeye CM-206 Bedienungsanleitung PDF herunterladen

Please carefully read these instructions before using this product.

Save this document for future use.

30657AA

model no: CM-206

CM-206L9

High Resolution Indoor

Dome Camera

Camera Installation & Conﬁ guration

Regulatory Compliance

General Speciﬁ cations Camera Overview Camera OSD Menu

Hardware Kit Contents

Camera Adjustments

Adjusting the Camera

Emissions FCC part 15 Class B

CE: EN55011

ICES-003

EN55022

CISPR 11

CISPR22

ANSI C63.4

Immunity CE: EN50130-4

FCC COMPLIANCE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in as

residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation.

If this equipment does harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try \to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced Radio/TV technician for help.

CISPR 22 WARNING:

This is a Class B product. In a domestic environment this product may cause radio interference in which case the

user may be required to take adequate measures.

POWER SUPPLY REQUIREMENTS:

For use with listed Audio/Video product and only connected to 15W or less power supply.

*Power supply should be a NEC Class 2 / LPS Supply.

EQUIPMENT MODIFICATION CAUTION:

Equipment changes or modiﬁ cations not expressly approved by the manufacturer, the party responsible for FCC

compliance, could void the user’s authority to operate the equipment and could create a hazardous condition.

This class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

• Wall anchors (x3)

• D5 screws (x3)

• T6 screw (x1)

• ¾” cable entry sealing plug

• Torx Driver

• Quick Install Adapter

• Wire-Ended Power Adapter Lead

The following illustration shows the service board which allows you to control the On

Screen Display (OSD) and make any programming changes required.

With the exception of the Focus (A) and Field of View (B) controls on the camera, all

settings are made using the keys on the OSD Service Board. When making adjust-

ments using the OSD Service Board, the camera must have power and be connected

to a video display.

1. Press and hold the MENU key for three seconds to access the top level menu.

2. Use the arrow keys on the service board to navigate the OSD menu and use the

MENU key to conﬁ rm your selections.

3. When you have completed the camera conﬁ guration, you must select EXIT to

save your changes.

4. If necessary, you can reset the camera to the factory default settings by selecting

RESET in the OSD menu.

Dead Pixel Compensation: The CM-206 camera has a feature that can cover most

dead pixels that could occur over time. To enable this feature:

1. Select DPC under the SPECIAL menu.

2. Cover the lens with your hand to black out the image and press the MENU key.

3. When the DPC feature is enabled, the camera will return to the menu. It may take

up to 30 seconds.

A: Focus Adjuster

B: Field of View Adjuster

C: Service Monitor Jack

D: Service Board

DOWN

LEFT RIGHT MENU

Model No. CM-206 CM-206L9

Image Sensor 1/3” Sony SuperHAD II

Imaging DSP V6

IP Rating IP55

Type / Format NTSC/PAL

Wide Dynamic Range Yes, Digital WDR

Minimum Illumination 0.3 Lux @ F1.2 (50 IRE), AGC Max

Day / Night Digital Day / Night

Resolution 600 TVL

Service Monitor Jack Yes

S/N Ratio >50dB

Focal Length 3.3 ~ 12 mm 9 ~22 mm

Iris Control Automatic

Synchronization Internal

Video Output 1.0Vpp 75Ω BNC Unbalanced

White Balance AWB, ATW, ATW2, AWC, MWB, Indoor, Outdoor

Auto White Balance Range 2700K ~ 9700K (AWB/ATW), 2500K ~ 20,000K (AWT2)

Backlight Compensation On, Off, HLC

Auto Gain Control Low, Mid, High, Off

Operating Temperature 14˚ ~ 122˚ F (-10˚ ~ 50˚C)

Heater No

Power Consumption 2.4W Max

Rated Amperage 0.2A (12vDC) / 0.1A (24vAC)

Imput Voltage 12vDC / 24vAC (± 10%)

Weight 0.6 lbs (0.27 kg)

Dimensions Dome : ø3.9” (100 mm) x H: 2.1” (55 mm)

Housing: ø4.7” (120 mm) x H: 1.9” (50 mm)

Housing / Dome Cover White / Clear

Day/Night Auto D/N Level 0~216

D/N Delay 1~30 Sec

N/D Level 0~206

N/N Delay 1~30 Sec

Color Return Ret/End IR Gain 0~255

B/W Burst Off/On Height 0~15

EXT IR Smart Off/On On Width 0~15

IR Level 0~206 Left/Right 0~15

Return 1~30 Sec Top Bottom Ret/End

Exposure



Shutter 1/50, FLK, 1/250, 1/500, 1/1000, 1/2000, 1/4000,

1/5000, 1/10000, 1/100000, AUTO

Brightness 0~255

AGC Off/Low/Middle/High

DWDR Off/On On Level 0~63

Return Ret/End Return Ret/End

Lens DC

Manual

White Balance ATW1 Color Temp Manual/Indoor/Outdoor

ATW2 Blue 0~255

AWC Set Red 0~255

Manual Return Ret/End Area Sel. Area 1~2

Backlight Off Area State Off/On

BLC Gain 0~25

HLC Level 0~255 Height 0~15

Mode All Day / Night Only Width 0~15

Return Ret/End Left/Right 0~15

Top/Bottom 0~15

Return Ret/End

Image Adj.



Lens Shad Off/On On Level 0~255

2DNR Off/On Return Ret/End

Mirror Off/On

Font Color



Font 0~15

Contrast 0~255 ID & Title 0~15

Sharpness 0~31 Return Ret/End

Display CRT Ped Level 0~63

Color Gain 0~255

Return Ret/End

LCD Gamma 0~63

Ped Level 0~255

Color Gain 0~255

Return Ret/End

User Gamma 0~63

Ped Level 0~255

Color Gain 0~255

Return Ret/End

Neg. Image Off/On

Return Ret/End

Special



Cam Title Off/On On Color/Pos/End

Motion Off/On On Area Sel. Area 1~4

Area State Off/On

Height 0~15

Width 0~15

Left/Right 0~15

Privacy Off/On On Top/Bottom 0~15

DPC



Degree 0~15

Version 000001 View Off/On

Return Ret/End Return Ret/End

Area Sel. Area 1~8

Area State Off/On

Height 0~149

Reset Factory Reset Width 0~199

Left/Right 0~200

Top/Bottom 0~144

Color 0~15

EXIT Return Ret/End

23221 E Knox Ave

Liberty Lake, WA 99019

1.888.542.1103

www.openeye.net

1 2

Inhaltsverzeichnis

Seite 1 - Dome Camera

Please carefully read these instructions before using this product.Save this document for future use.30657AAmodel no: CM-206 CM-206L9High Resolution

Seite 2 - Installation Instructions

InstallationTemplateInstallation InstructionsPrecautions• Do not attempt to dismantle the camera module mounted within the dome. There are no user se

Verwandte Modelle: CM-216

Kommentare zu diesen Handbüchern

Keine Kommentare

Openeye CM-206 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Videoüberwachungssysteme Openeye CM-206 herunter. OpenEye CM-206 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: CM-216

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Videoüberwachungssysteme Openeye CM-206