Openeye CM-816 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Videoüberwachungssysteme Openeye CM-816 herunter. OpenEye CM-816 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken

Inhaltsverzeichnis

Seite 1 - Outdoor PTZ IP Camera

AccessoriesCA-510GCA-510WCA-510CCA-510P25CA-510P50CA-510PMLCA-510PMSCA-510PA25CA-510PA50CameraCM-816www.openeye.netOutdoor PTZ IP CameraUser Manual

Seite 2 - 30875AF 3

30875AF 11 Before proceeding, please check that the box contains the items listed here. If any item is missing or has defects, do not install or oper

Seite 3 - Precautions

12 Before installing or connecting the dome camera, please refer to this section and complete preparations for dome setup and all switch settings. Pr

Seite 4 - Warning

30875AF 13 3. Remove the protective cover and PE sheet. 4. Apply some lubricant on the cover’s waterproof gasket. This helps make the installatio

Seite 5 - C A U T I O N

14 7. Using both hands, gently press the dome cover. DO NOT press the dome itself as this may cause damage to the dome or camera. 8. Screw the d

Seite 6 - 30875AF 7

30875AF 15 Dome Camera Setup Please refer to the following figure for connection and switch locations and definitions. Do not change the settings

Seite 7

16 Dome Cable Definition and Requirements For operation, the IP dome camera requires a network cable to carry the video signals to the remote viewing

Seite 8 - 30875AF 9

30875AF 17 1. Connect POSITIVE 24 volt AC power to pin 1. 2. Connect ground wire to pin 2. 3. Connect NEGATIVE 24 volt AC power to pin 3. The ‘no

Seite 9 - Product Features

18 Using the 12-pin connector, installers can connect 4 digital alarm inputs and 2 digital alarm outputs. The alarm pins are serviceable for connectin

Seite 10 - 30875AF 11

30875AF 19 Depending on your installation environment, the dome can be installed on the ceiling, on a wall, or a pole. The following section illustr

Seite 11 - Preparations for Dome Setup

20 Dome Camera Accessories Transparent/Smoke Cover Part Number: CA-510-DT Mounting Accessories Wall Mount Bracket (w/ Anti Drop) Part Number: CA-510W

Seite 12 - 30875AF 13

30875AF 3 18x 2MP Outdoor IP PTZ Camera (CM-816 Rev C) User Manual Manual Edition 30875AF – APRIL 2015 ©2015, OPENEYE All Rights Reserved. No

Seite 13

30875AF 21 Ceiling Mounting with Pole The pole is available in two lengths: 25 cm and 30 cm. Items Needed:  Dome Camera  Ceiling Pole Accessory

Seite 14 - Dome Camera Setup

22 Wall Mounting with Wall Mount Bracket Items Needed:  Dome Camera  Wall Mount Bracket or Long Wall Mount Bracket  Waterproof Gasket (supplied)

Seite 15

30875AF 23 4. Attach the wall mount bracket to the wall with the appropriate screws and screw anchors (not provided). 5. Attach the waterproof gas

Seite 16 - 30875AF 17

24 Wall Mounting with Corner Mount The corner mount must be used in conjunction with the wall mount bracket. Items Needed:  Dome Camera  Wall Mou

Seite 17

30875AF 25 Pole Mounting The dome can be mounted on a pole with the small or large direct mounting accessory and a wall mount bracket. Items Needed:

Seite 18 - 30875AF 19

26 OpenEye Network Camera Manager is a software tool that allows you to quickly and easily connect and configure your OpenEye IP Cameras. This softwar

Seite 19 - Mounting Accessories

30875AF 27 1. To view a network camera over the web using the camera’s viewer software, double-click the name of the camera. 2. Click Browse. 3. E

Seite 20 - Ceiling Mounting with Pole

28 Device Addressing The functions on the Device Addressing tab allow you to find, configure, and view network cameras. 1. Click Find Devices on the

Seite 21

30875AF 29 Connecting to the Camera 1. Locate the camera on the IP Finder list. 2. Double-click the camera to open the Viewer software in your web

Seite 22 - 30875AF 23

30 There are some challenges with connecting to OpenEye IP cameras over WAN (internet) connections because the camera streams video over RTSP. RTSP is

Seite 23

4 Important Safeguards 1. Read Instructions Read all of the safety and operating instructions before using the product. 2. Retain Instructions Save

Seite 24 - Pole Mounting

30875AF 31 To access the setup menu, you need to install the viewer software on your PC or recorder. The viewer software will install automatically t

Seite 25 - Installation

32 Full Screen – This will display the live feed in full screen. Snapshot – Click the button, and a JPEG snapshot will automatically be sav

Seite 26 - 30875AF 27

30875AF 33 The Setup menu includes System Settings, Picture Setup, and Streaming Settings. The Setup menu displays limited setup options. For a com

Seite 27 - Device Addressing

34 IP Address You can choose to use a fixed IP address or a dynamic IP address (assigned by a DHCP server or router) for the camera. The camera co

Seite 28 - Connecting to the Camera

30875AF 35 To set up a new static IP address: 1. Select the Use static IP address option. 2. Type a new IP address in the IP address box. 3. Type

Seite 29

36 User Setup Manage the password for the Administrator account. To change the administrator password: 1. Type a new Administrator Password, and the

Seite 30 - Viewer Tabs

30875AF 37 1. Select the user name on the User Name list. 2. Click Edit. 3. In the resulting window, modify the Password and/or feature permission

Seite 31

38 Min Shutter Speed – Choose a pre-determined shutter speed. Manual Mode – Changing the shutter mode to manual will allow you to select the minimum s

Seite 32 - Camera Name

30875AF 39 Motion Detection Use the Motion Detection menu to configure the motion detection window(s). Here, Motion Detection can be turned On or Off

Seite 33 - IP Address

40 Motion Window The motion window displays a red line and a dynamic blue line. The red line represents the Detection Level. The blue line will also b

Seite 34 - IPv6 Address Configuration

30875AF 5 Installation and Storage  Install electricity wiring carefully. Please note that input electricity to the unit is at tolerance of DC 12V/

Seite 35 - User Setup

30875AF 41 Video Resolution The camera provides eight codec options under video resolution (two single streaming options, two sets of dual streaming

Seite 36 - Camera Tab

42 Normal Video – The video will be oriented as the camera position dictates. 180 Degree Rotate – Rotate the video 180 degrees. 90 Degree Clockwise –

Seite 37

30875AF 43 Video Frame Rate Setting the camera to transmit fewer frames can save bandwidth. Use the Frame Rate Control screen to adjust the frame rat

Seite 38 - Motion Detection

44 Video Compression You can select an MJPEG / H.264 compression mode on the video compression page appropriate for your application. You can a

Seite 39 - Motion Window

30875AF 45 Network Setup The Network Setup settings will automatically be set at the recommended default after the camera connection is made. DDNS

Seite 40 - Video Resolution

46 With Simple Network Management Protocol (SNMP) enabled, the camera can be monitored and managed remotely with a network management system. Contact

Seite 41

30875AF 47 Network Security The camera can send alarm messages to a specific Hypertext Transfer Protocol (HTTP) site when motion is detected or when

Seite 42 - Video Frame Rate

48 Alarm Application The alarms menu is where alarm connections are configured. Alarm Switch – Designate when the alarm will be active; Off, On, or B

Seite 43 - Video Compression

30875AF 49 Tampering and Network Failure Detection Tampering Alarm – Turn the Tampering Alarm On, Off, or On By Schedule. Tampering Duration – Design

Seite 44 - Network Advanced

50 Mail, HTTP and FTP Setup The camera can send an e-mail via Simple Mail Transfer Protocol (SMTP) when a variety of events occur. SMTP is a protocol

Seite 45

6 Caution .CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).NO USER-SERVICEABLE PARTS INSIDE.REFER SERVICING TO QUALIFIE

Seite 46 - Network Security

30875AF 51 Network Share Network Share is a network protocol that runs a variety of different system platforms, allowing for file sharing between com

Seite 47 - Alarm Application

52 Recording Schedule The recording schedule allows you to set up scheduled recording to the microSD™ card or to Network Sharing. This section allows

Seite 48 - 30875AF 49

30875AF 53 This section allows you to establish schedules to use in other section. To create a schedule: 1. Select a Schedule set (1-10). 2

Seite 49 - SD Card

54 Interval recording allows you to record in consistent intervals and save the files for later viewing. 1. Turn Interval Recording On or Off. 2.

Seite 50 - Network Share

30875AF 55 Maintenance On the Maintenance page you can export the cameras current configuration, or import the configuration for a camera. Use the fa

Seite 51 - Recording Schedule

56 Software Make sure the software upgrade file is available before starting the software upgrade. 1. Click Browse and find the upgrade file. Do

Seite 52 - 30875AF 53

30875AF 57 Audio Audio Input Grain – sets the amplification that the camera applies to the incoming audio before transmitting. Audio Output Delay – S

Seite 53

58 Model CM-816 Rev C Maximum Resolution 1080p (2MP) Image Sensor 1/2.8” Sony Progressive CMOS Video Compression H.264 / MJPEG Frame Rate 30 IPS @ 108

Seite 54 - Maintenance

30875AF 59 Heater Yes Heater Operation Threshold ON: -7ºC ~ OFF: 3ºC Active/Passive Cooling Active (Fan) Power Consumption 59W Max (Heater On) Rated

Seite 55 - Text Overlay

60 www.openeye.net 1-888-542-1103 © 2015 OpenEye All rights reserved. No part of this publication may be reproduced by an

Seite 56 - 30875AF 57

30875AF 7 Introduction ... 10 Overview ...

Seite 57

8 Finding Network Devices ... 28 Connecting to the Camera ...

Seite 58 - 30875AF 59

30875AF 9 Video Compression ....... 44 Advanced ...

Seite 59

10 The CM-816 IP camera can transmit video in H.264 and MJPEG, up to 2MP (1080p) high definition video. The 816 is capable of quad and dual streaming

Kommentare zu diesen Handbüchern

Keine Kommentare